BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE 20-BD5476-00
©
2017 BROADSOFT INC. PAGE 70 OF 150
5.2.5.2.2 Configuration Method 2: Manual
This section identifies the manual steps necessary configure BroadWorks to add the
Device Management Defaults device type for No Touch Provisioning
The manual method must be used for BroadWorks releases prior to Release 17.0. It is an
optional method in Release 17.0 and later. The steps in this section can also be followed
to update previously imported or configured device profile type(s) with new configuration
files and firmware.
5.2.5.2.2.1 Create Default Device Profile Type
A Device Management default device profile type must be created. This device profile
type can be configured to serve default provisioning files to Yealink T4x endpoints, as well
as other vendor devices.
Create a default device profile type as shown in the following figure. Only the device
management settings are important in this context since the profile type is used only to
serve default provisioning files. The standard and advanced settings do not matter.
5.2.5.2.2.1.1 Configure Standard Options
The device profile type name and standard options do not matter, but an example is
provided for reference. All settings can be left with their default values.
Figure 40 Default Device Profile Type
5.2.5.2.2.1.2 Configure Advanced Options
The advanced options do not matter, but an example is provided for reference. All
settings can be left with their default values.
To Next Page
Loading...
Need help?
General
