User Guide for the VC400 Video Conferencing System
18
Press the key on the remote control.
The camera is not connected properly to the VC400 codec,
or the VC400 codec is powered off.
Indicator LED on the VCP40:
The phone is initializing.
The VCP40 is muted when the VC400 is during a call.
The phone is placing a call.
There is an active call on the phone.
The phone is idle.
The phone is not connected to the VC400 codec correctly.
Indicator LED of the Internet port on the VC400 codec:
Indicator LED on the left is off
Network is not connected.
Indicator LED on the left is solid green
Indicator LED on the right is flashing yellow
Sending and receiving data.
Indicator LED of the Internet port on the VC400 codec:
Indicator LED on the left is off
Network is not connected.
Indicator LED on the left is solid green
Indicator LED on the right is flashing yellow
Sending and receiving data.
User Interfaces
There are two ways to customize the configurations of your VC400 video conferencing system:
Web User Interface
Remote Control
Note
The display device and remote control constitute the system user interface. This allows the user
to execute all call operation tasks and basic configuration changes directly. Detailed operational
steps will be explained in the feature section.
To Next Page
Need help?
General
Weight and Dimensions
