YOKOGAWA wt3000 User Manual

7-14 IM 760301-01E
7.7 Selecting the Display Interpolation and
Graticule and Turning ON/OFF the Scale Value
and Waveform Label
Procedure
START STOP
REMOTE
CAL
SENSOR RATIO
MEASURING
RMS MEAN DC RMEAN
CURRENT RANGEVOLTAGE RANGE
MEASURING
RMS MEAN DC RMEAN
ALL
INPUT INFO.
LOWER ITEM LOWER FORM ALLUSER SET
DISPLAY ITEM & ELEMENT
2
34
COMPEN
ELEMENT
ELEMENT
1
WIRING
MODE AUTO MODE AUTO
EXT SENSOR
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
RESET SET
PAGE PAGE
Cursor keys
To exit the menu during
operation, press ESC
located above the soft
keys.
In the procedural
explanation below, the
phrase “press the cursor
keys” may be used. This
phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14.
1. Press FORM to display the Trend Form menu.
If the trend display is at the lower section of the screen on the split display, press
SHIFT + FORM (LOWER FORM).
2. Press the Display Setting soft key to display the Disp Setting menu.
• Selecting Whether to Interpolate the Display
3. Same as the procedure given in “Selecting Whether to Interpolate the Display”
in section 6.7.
• Changing the Graticule
3. Same as the procedure given in “Changing the Graticule” in section 6.7.
• Turning ON/OFF the Scale Value Display
3. Same as the procedure given in “Turning ON/OFF the Scale Value Display” in
section 6.8.
• Turning ON/OFF the Waveform Label
3. Same as the procedure given in “Turning ON/OFF the Waveform Label” in
section 6.8.

YOKOGAWA wt3000 Specifications

General

Brand	YOKOGAWA
Model	wt3000
Category	Measuring Instruments
Language	English