8-11
IM 760301-01E
8
Storing and Recalling Data and Saving the Stored Data
8.4 Storing Data
Procedure
START STOP
REMOTE
CAL
MOTOR
SET
CURSOR NULL
MENU STORE SET
MENU
LOWER ITEM LOWER FORM ALL
USER SET
DISPLAY
ITEM & ELEMENT
RESET SET
PAGE PAGE
SCALING
HRM SET
MEASURE
SYNC SOURCE
AVG
LINE FILTER
FREQ
FILTER
FILE
PRINT
MISC
STORE
IMAGE SAVE
HELP
NUMERIC
WAVE
OTHERS
ITEM
FORM
U / I / P
WP/q/
TIME
USER
ELEMENT
UPDATE
RATE
HOLD
SINGLE
INTEG
LOCAL
SHIFT
To exit the menu during operation, press ESC located above
the soft keys.
In the procedural explanation below, the phrase “press the
cursor keys” may be used. This phrase refers to the
procedures for selecting items and entering values and
character strings. For details on the procedures, see section
3.14.
Cursor keys
If you are storing data for the first time after turning the power switch ON, start
from step 1. If you stored the data before and the data is stored in the internal
memory, proceed to step 6 to clear the internal memory.
To set or execute the storage operation, set the measurement mode to normal
measurement mode or wide bandwidth harmonic measurement mode.
*1
There
are limitations on the setting and execution of the storage operation in
measurement modes other than normal measurement mode.
To store waveform display data, set the display mode to Wave, Numeric+Wave,
Wave+Trend, or Wave+Bar
*2
and display the waveform on the screen. For the
setup procedure, see section 6.1.
*1 Displayed only to products with the advanced computation (/G6) option.
*2 Displayed only on models with the advanced computation (/G6) or harmonic measurement (/
G5) option.
• Starting the Storage Operation
1. Press SHIFT+STORE(STORE SET) to display the Store Set menu.
2. Press the Mode soft key to select Store.
3. Press the Store to soft key to select Memory.
4. Press STORE. The storage operation starts according to the following
conditions depending on the store mode (see section 8.1).
• During manual mode
Starts the storage operation. When STORE is pressed, the first storage
operation is executed. The STORE key illuminates, and “Store:Start” is
displayed in the upper left corner of the screen.
• During real-time mode
The WT3000 enters store ready state. The STORE key blinks, and
“Store:Ready” is displayed in the upper left corner of the screen. When the
reservation time for starting the storage operation is reached, the first storage
operation starts. The STORE key illuminates, and “Store:Start” is displayed in
the upper left corner of the screen.
• During integration synchronization mode
The WT3000 enters store ready state. The STORE key blinks, and
“Store:Ready” is displayed in the upper left corner of the screen. When
integration starts, the first storage operation starts. The STORE key
illuminates, and “Store:Start” is displayed in the upper left corner of the screen.
To Next Page
Loading...
Need help?
General
