JOHNSON CONTROLS
117
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
FORM 160.67-O1
ISSUE DATE: 4/1/2015
2
SECURITY LOG SCREEN
FIGURE 46 - SECURITY LOG SCREEN
00662VIP
NOTE: OptiView
™
Control Center Screens shown may NOT represent the exact screens according to the software version utilized.
OVERVIEW
This screen displays a listing of the last 75 setpoint
changes. They are listed and numbered in reverse or-
der in which they were changed, with the most recent
listed as number 1. Multiple pages are necessary to dis-
play all 75 changes. Not all setpoints are logged. Ser-
vice technicians refer to list in YORK Service Manual
160.67-M3.
The details of any setpoint change can be viewed by
navigating to a subscreen that displays the date and
time of the change, Access Level and USER ID used
to make the change, the old setpoint value and the new
setpoint value.
Requires a login access level of SER-
VICE.
DISPLAY ONLY
Category
Displays the category of the setpoint (motor, evapora-
tor, condenser, etc.)
Setpoint
Displays the setpoint that was changed.
New Value
Displays the value that was entered at the time of the
setpoint change.
PROGRAMMABLE
Log Entry
Allows the user to select a particular setpoint change
for detail viewing.
Print
Generates a detailed report of all setpoint changes list-
ed in the setpoint change log.
Page Up
Scroll up in the displayed data (if applicable).
Page Down
Scroll down in the displayed data (if applicable).
To Next Page
Loading...
Need help?
General
