JOHNSON CONTROLS
88
FORM 160.67-O1
ISSUE DATE: 4/1/2015
SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION
SALES ORDER SCREEN
00320VIP
FIGURE 33 - SALES ORDER SCREEN
NOTE: OptiView
™
Control Center Screens shown may NOT represent the exact screens according to the software version utilized.
OVERVIEW
This screen allows definition of the sales order parame-
ters. The Commissioning date is entered by the YORK
Service Technician at the time of chiller commission-
ing. These values should never be changed or entered
by anyone other than a qualified Service Technician.
Entry instructions are included in the YORK Service
Manual 160.67-M3. The remainder of the values are
entered at the YORK Factory during the manufacturing
of the chiller.
DISPLAY ONLY
Model Number
Factory defined model number of the chiller system.
Panel Serial Number
Factory defined serial number for the micropanel.
Chiller Serial Number
Factory defined serial number for the chiller system.
YORK Order Number
Factory defined order number under which the chiller
was sold.
System Information
Factory defined conditions for which the chiller was
originally rated and sold.
Evaporator, Condenser and Steam Condenser
Information
Factory defined description of the evaporator, refrig-
erant condenser, and steam condenser configuration at
time of shipment.
Turbine Information
Factory defined information about the turbine design
and steam requirements for design load conditions.
PROGRAMMABLE
Commissioning Date
Access Level Required: SERVICE
Define the date at which the chiller was commissioned.
Job Name and Location
Access Level Required: SERVICE
Factory defined job name and location the chiller is
destined for.
To Next Page
Loading...
Need help?
General
