take effect.
2.10. System
Clear Settings:Clear all the Settings in the camera and set them to default values.
Format Card:Format the CFast card or the external SSD connected through USB
Type C port (if there is no CFast card in the camera). Please note that formatting
will erase ALL DATA in the storage!
Attention: When using a CFast or SSD on Z CAM E2 for the first time, please format
it on the computer in exFAT format, and then format it in the camera.
Assist Tools: There is three sub-items in this setting: Display / Peak / Exposure /
Frame Line / Center Mark /
Display: On / Off. To enable or disable the assist tool on the display. Please
note that when the assist tool is enabled, the effect will be output through HDMI
together with the video stream. So you would need to turn it off if you are using
external recorder though HDMI connection.
Scope: Tool / Opacity
- Tool: Disable / Waveform / Parade / Vectorscope, for HDMI output o’n’ly
- Opacity: 10~100, adjust the tool’s brightness on the monitor when it’s
enabled.
Peak: Enable / Color / Monochrome / Threshold
- Enable: Off / On, to enable / disable the Peak tool and set the color of
peaking focus.
- Color: Red, Green, Blue, Orange and White, choose the color of peaking
focus display.