Zapi AC-0 SSL User Manual

AE0ZP0EC - AC-0 SSL SENSORED - User Manual Page - 25/100
A11 PEV (+B) This output provides a +Batt for the electrovalves coils
connected to the MDI PRC; 3 A maximum current.
A12 -BATT -Batt.
A13 MOT TH Motor thermal sensor input. The internal pull-up is a
fixed 2 mA (Max 5 V) source current.
A14 LIFT AUX. Auxiliary lifting request input, active high.
A15 LOW AUX. Auxiliary lowering request input, active high.
A16 +12V This output provides a +12 V signal for the MDI PRC;
100 mA maximum current.
A17 CAN HIGH High level CAN-BUS voltage I/O.
A18 CPOTB Proportional electrovalves potentiometer wiper.
A19 ENC A Encoder Channel A.
A20 ENC B Encoder Channel B.
CNB connector
B1 KEY SW Connected to the power supply through a microswitch
(KEY) with a 6.3-10 A fuse in series (this can be
mounted on the AC-0 cover).
B2 CM Common of FW / BW / LIFT AUX / LOW AUX / TILLER
/ H&S / BELLY / LIFTING / LOWERING microswitches.
This connection supplies a key voltage level.
B3 TILLER SW Tiller request input. Must be connected to the tiller
microswitch, active high.
B4 H&S SW Hard & Soft request input. Must be connected to the
Hard & Soft microswitch, active high.
B5 BACKWARD SW Backward direction request input. Must be connected
to the backward direction microswitch, active high.
B6 FORWARD SW Forward direction request input. Must be connected to
the forward direction microswitch, active high.
B7 BELLY SW Quick inversion function input; must be connected to
the Belly microswitch; it is active high.
B8 LOWERING SW Lowering request input, active high.
B9 LIFTING SW Lifting request input, active high.
B10 CPOT Accelerator potentiometer wiper.
B11 NPOT Negative of accelerator unit, tested for wire
disconnection diagnosis.
B12 PPOT Potentiometer positive: 10 V output; keep load > 1 kΩ.
CNC connector
C1 PCLRXD Positive serial reception.
C2 NCLRXD Negative serial reception.
C3 PCLTXD Positive serial transmission.
C4 NCLTXD Negative serial transmission.
C5 GND Negative console power supply.
C6 +12V Positive console power supply.
C7 FLASH Must be connected to C8 for the Flash memory

Zapi AC-0 SSL Specifications

General

Brand	Zapi
Model	AC-0 SSL
Category	Inverter
Language	English