Zapi AC-0 SSL User Manual

Page - 24/100 AE0ZP0EC - AC-0 SSL SENSORED - User Manual
B9 LIFTING SW Lifting request input, active high.
B10 CPOT Accelerator potentiometer wiper.
B11 NPOT Negative of accelerator unit, tested for wire
disconnection diagnosis.
B12 PPOT Potentiometer positive: 10 V output; keep load > 1 kΩ.
CNC connector
C1 PCLRXD Positive serial reception.
C2 NCLRXD Negative serial reception.
C3 PCLTXD Positive serial transmission.
C4 NCLTXD Negative serial transmission.
C5 GND Negative console power supply.
C6 +12V Positive console power supply.
C7 FLASH Must be connected to C8 for the Flash memory
programming (if used).
C8 FLASH Must be connected to C7 for the Flash memory
programming (if used).
6.1.2 MDI PRC version with Encoder
Figure 6–3
CNA connector
A1 NMC Negative of main contactor coil.
A2 PMC Positive of main contactor coil
A3 NEB Output for driving the electromechanical brake coil;
drives the load to -Batt. Maximum current: 3 A.
A4 NPC Negative of pump contactor coil.
A5 PPC Positive of pump contactor coil and of the auxiliary
output load.
A6 AUX OUT Negative of the auxiliary output.
A7 CAN LOW Low level CAN-BUS voltage I/O.
A8 -BATT -Batt.
A9 ENC + Encoder Positive Supply (+5 or +12 Vdc).
A10 ENC - Encoder Negative Supply (GND to minus battery).

Zapi AC-0 SSL Specifications

General

Brand	Zapi
Model	AC-0 SSL
Category	Inverter
Language	English