Zapi AC-0 SSL User Manual

AE0ZP0EC - AC-0 SSL SENSORED - User Manual Page - 49/100
- RUNNING: The counter registers travel time only.
- KEY ON: The counter registers when the "key" switch is closed.
5) BATTERY CHECK
This option specifies the handling of the low battery charge detection. It can
be set one of three:
- Level 0: Nothing happens, the battery charge level is ignored.
- Level 1: A BATTERY LOW alarm is raised when the battery level
is calculated being less than 10% of the full charge. A
BATTERY LOW alarm inhibits the Lifting function.
- Level 2: Equivalent to Level 1.
- Level 3: Equivalent to Level 1.
6) HYDRO KEY ON
- ON/OFF: If this option is programmed ON the pump inverter
manages an hydraulic steering function when the "key" is
switched ON (only if the AUX OUTPUT #1 option is
programmed as HYDRO CONTACTOR or as
EXCLUSIVE HYDRO).
7) AUX OUTPUT #1
Not used.
8) AUX VOLTAGE #1
This option specifies the percentage of the key voltage to be applied to the
loads on CNA#1 (main contactor coil) and CNA#3 (aux output). The voltage
modulation is got with a PWM at 1 kHz frequency. After an initial delay of
about 1 sec in which the entire key voltage is applied to the loads, the PWM
reduces the voltage at the loads down to the specified percentage.
9) TRUCK TYPE
Not used.
10) VALVE 1 TYPE
Not used.
11) VALVE 2 TYPE
Not used.
"ADJUSTMENTS" SUBMENU
1) MIN LIFT
Not used.
2) MAX LIFT
Not used.
3) MIN LOWER
Not used.
4) MAX LOWER
Not used.
5) MOTOR OVERTEMP
With this setting, it is possible to raise a warning when the motor temperature
overtakes a threshold specified by the MOTOR OVERTEMP value.

Zapi AC-0 SSL Specifications

General

Brand	Zapi
Model	AC-0 SSL
Category	Inverter
Language	English