Zapi COMBI AC1 User Manual

- NONE: No CHECK UP NEENED warning
- OPTION#1: CHECK UP NEENED warning shown on the hand set and
MDI after 300 hours
- OPTION#2: Equal to OPTION#1 but Speed reduction after 340 hours
- OPTION#3: Equal to OPTION#2 but the truck definitively stops after 380
hours
11) MAIN CONT. VOLTAGE
Percentage of the total voltage of the battery applied to the main contactor
coil.
12) AUX OUTPUT VOLTAGE
Percentage of the total voltage of the battery applied to the Eb coil.
9.4.3 Main menu “PARAMETER CHANGE” functions list
To enter the MAIN MENU’ it is just necessary to push the ENTER button from the
home display in the hand set.
1) Opening Zapi Menu
CA1S2B ZAPI 0.00
24V 350A 00000
2) Press ENTER to go into the General Menu
' % '
' ' '
3) The Display will show: PARAMETER CHANGE
MAIN MENU
PARAMETER CHANGE
4) Press ENTER to go into the Parameter
Change menu
' % '
' ' '
5) The Display will show the first parameter
ACC DELAY
LEVEL = 5
6) Press either ROLL UP and ROLL DOWN to
display the next parameter
% ' '
% ' '
7) The names of the Parameters appear on the
Display
RELEASE BRAKING
LEVEL = 5
8) When the desired Parameter appears, it’s
possible to change the Level by pressing either
SET UP or SET DOWN buttons.
' ' %
' ' %
9) The Display will show the new level.
RELEASE BRAKING
LEVEL = 2
10) When you are satisfied with the result of the
changes you have made, press OUT.
' ' '
' % '
11) The Display asks: “ARE YOU SURE?”
ARE YOU SURE?
YES=ENTER
NO=OUT
12) Press ENTER to accept the changes, or press
OUT to discard them.
' ' '
' % '
Page - 44/86 AEQZP0BA – COMBI AC1 - User Manual

Zapi COMBI AC1 Specifications

General

Brand	Zapi
Model	COMBI AC1
Category	Inverter
Language	English