10 - 8 DS3408 Product Reference Guide
Convert Code 39 to Full ASCII
By default, any characters that do not have a corresponding character in the Code 39 symbology set are replaced
by a space. Enable this parameter to encode data sent to the wand Interface in Code 39 Full ASCII. The host must
be able to interpret Code 39 Full ASCII data.
This setting applies only if Convert to Code 39 is also enabled.
*Disable Code 39 Full ASCII Conversion
Enable Code 39 Full ASCII Conversion
NOTE Wand Emulation emits an error beep when there is an attempt to send composite data. No data is sent.
To Next Page
Loading...
Need help?
General
