11_
3.6 FEET INSTALLATION
Line up the guide pegs on the feet with the holes on the underside of
the Scout’s body so that the screws in the feet match up with the screw
holes on the underside of the Scout.
3.7 REMOTE CONTROL
1. Ensure that the Remote Control power switch is in the OFF (down)
position.
2. Open the battery cover by unscrewing the securing screw and sliding
down the open tab.
3. Insert 4 x AA batteries (AA batteries not included) making sure that
they are in the orientation specified.
4. FLIGHT SAFETY
Before flying your Scout make sure that you are in a safe setting. CASA
restrictions regarding flying drones require the drone to be no closer than
5.5kms from any airport or airfield whilst flying. Drones should also not be
flown over populated areas or any closer than 30 metres from vehicles people
or animals.
It is also required that you check your surroundings before taking off making
sure there are no obstacles or dangers in the area including overhead power
lines and bodies of water. If there are hazards present in your intended area
of flight, please consider an alternative location.
To Next Page
Loading...
Need help?
General
