9_
3. SETTING UP YOUR ZER0-X SCOUT
3.1 CHARGING THE BATTERY
PLEASE NOTE: YOUR ZERO-X DRONE COMES WITH A CERTIFIED ZERO-X USB
AC CHARGING ADAPTER FOR 240v CHARGING OF YOUR DRONE BATTERY.
USE OF A NON ZERO-X CERTIFIED USB AC CHARGING ADAPTER WILL VOID
YOUR WARRANTY AND MAY DAMAGE BOTH YOUR BATTERY AND DRONE.
Fully unwind the included USB charging cable and plug the USB end
into the included Zero-X Certified USB AC charging adapter. When
connected to a charging source the LED light in the charger will turn off.
Connect the drone battery to the charging cable and the light will glow
red indicating charging is in process. The LED on the USB charging cable
will turn off again once charging is complete. To keep the battery life as
long as possible avoid removing the battery from the charging cable
before charging is complete. If you have just finished flying your Scout
drone, please allow the battery to cool down for at least 30 minutes
before recharging.
• When the Scout battery has finished charging it is advised that the
battery is removed from the charger as soon as possible. Overcharging
will damage the battery and effect the flight time.
• The Scout battery can take up to 90 minutes to fully charge. If the battery
has been on charge for any longer than 2 hours and the indicator on
the charging cable is not showing that the battery is charged please
remove the battery from the charger.
• When connecting the USB cable with the battery, make sure to follow
the guides on the battery connector as these are designed to only
be inserted in one direction. Forcing the connection in the incorrect
direction, may cause damage to the battery and charging cable.
3.2 INSTALLING THE BATTERY
1. Open the battery flap on the underside of the Scout by sliding it
toward the rear of the drone being careful of the attached camera.
2. Insert the batery into the tray.
3. Connect the battery to the power cable and close the battery flap
making sure it is secure.
To Next Page
Loading...
Need help?
General
