7
Installation
a. Take out the quick release plate, mount the camera on the quick release plate
then tighten the 1/4" screw at its bottom.
b. Adjust the lens support on the quick release plate to make sure the stability of
the lens.
c. Slide the quick release plate to the stabilizer with three axes locked, then lock
the quick release plate latch.
Before mounting the camera, make sure it is prepared ahead of time. Remove
the lens cap and make sure the camera’s battery and memory card are al-
ready inserted.
Lift the quick release plate latch
up if it gets stuck. Adjust the
position of quick release plate
latch to ensure the camera is
neither too tight nor too loose.
Camera Installation
• Each axis of the stabilizer is equipped with a latch. You can use these latches to
lock the axes for convenient installation and storage.
Locked for installation Locked for storage
To Next Page
Loading...
Need help?
General
