Zhiyun Crane Plus User Manual

17 zhiyun-tech.com 18zhiyun-tech.com
Initialization and Various Operations
Initialization and Various Operations
Initializing the Stabilizer Firmware Upgrade
Initialization Procedure
Initialize the stabilizer under the following circumstances:
1. Slight deviation is found in the tilt angle of the camera in level position after startup.
2. Slight deviation is found in the roll angle of the camera in level position after startup.
3. Frequent small angle correction is found when the camera is in level position while the
stabilizer stays still.
1. Install the batteries properly.
2. Hold the camera mounting plate and long press the Power Button to turn on the stabilizer.
The motor will generate acting force upon activation, hold the camera mounting plate still,
and long press the Mode Button to enter standby mode.
3. Put the stabilizer still on a table surface, wait for about 10 sec., and the stabilizer will
automatically complete initialization.
If slight deviation can still be found after initialization, repeat the procedure above to initialize again.
1. Visit ZHIYUN's official website: www.zhiyun-tech.com.
2. Click to open the "Downloads" page, and find the Firmware Upgrade Tutorial package.
3. Download the driver, calibration tool and latest firmware corresponding to your stabilizer.
4. Upgrade firmware following the instructions indicated in the Firmware Upgrade Tutorial.
Make sure batteries are installed during upgrade.
USB

Zhiyun Crane Plus Specifications

General

Type	Hand camera stabilizer
Material	Aluminium, Polyblend
Motorized	Yes
Motor type	Brushless motor
Product color	Black
Tilt angle range	0 - 360 °
Angle of rotation	360 °
Maximum weight capacity	2.5 kg
Charging time	3 h
Operating time	18 h
Battery voltage	3.7 V
Battery capacity	3600 mAh
Operating temperature (T-T)	-10 - 45 °C
Package depth	355 mm
Package width	310 mm
Package height	103 mm
Package weight	2800 g
Cables included	USB

Weight and Dimensions

Depth	188 mm
Width	173 mm
Height	374 mm
Weight	950 g