3
®
2.Before installation please carefully read this user manual.
3.When you install the IP camera, please close the power source of all the related
devices.
4.Check the voltage of the power source, to prevent device damage by
mismatching of voltage.
Installation environment: please do not use equipment under high humidity or
temperature. Make sure there is good ventilation and no blocking of air-vent.
Place it on a at oor. Do not install it under violent vibration.
1.4 Network IP Camera Connection
Figure 1-3 Device Connection of Network IP Camera
Step one: Connect the IP Camera to your router or NVR using a network LAN
cable.
Step two: Connect the related power adapter to the IP Camera so that the
camera powers on.
Step three: Insert the Software CD into the PC computer that is connected to the
same local network as the IP Camera.
Note: It can also apply the way of IP Camera directly connecting with PC.
Note: When using IE browser to visit IP Camera, the IP of local PC should
be in the same segment with the IP of the IPC.
2 Log in
When using IE (Internet Explorer) to visit IP camera for the rst time, you have to
set the security level for ActiveX controls.
Set security level: Open Internet Explorer, enter the IE Tools menu [Tools/Internet
Options/Security Settings/Custom Level…], Enable the “Active X Controls and
Plugins” and set the IP address of the IP Camera as “Trusted sites”.
To Next Page
Loading...
Need help?
General
