31
1. On the AT&T Wi-Fi Manager home page, log in as Administrator.
2. Click Settings in the left-side menu.
3. Click Advanced > Router tab.
4. In the VPN Passthrough section, select Enable beside VPN Passthrough, and click
Apply.
Configure APN details
The APN is checked to determine the type of network connection to establish.
Your mobile hotspot comes preconfigured with the APN (Access Point Name) for
AT&T.
To add an APN for another network:
1. On the AT&T Wi-Fi Manager home page, log in as Administrator.
2. Click Settings on the navigation menu on the left side.
3. Click the Network > APN tab.
4. Select Manual beside Mode, and click Add.
5. In the blank line, enter the profile name, APN (obtained from your carrier).
6. Select the network Authentication mode. The options are:
· None (default)
· CHAP
· PAP
7. Enter the Username and Password, if these are required for the wireless network.
8. Click Save.
To select the APN entry to use:
From the drop-down box beside Profile Selection, select the desired APN to use.
To remove an APN entry:
Select the APN you want to remove, and click Delete.
Enable DMZ
In a DMZ (demilitarized zone) network configuration, a computer runs outside the
firewall in the DMZ. This computer intercepts incoming Internet traffic, providing an
extra layer of protection for the rest of the network.
To enable DMZ and designate a computer to screen incoming traffic:
1. On the AT&T Wi-Fi Manager home page, log in as Administrator.
2. Click Settings on the navigation menu on the left side.
3. Click the Firewall > DMZ tab.
4. Select Enable beside DMZ Settings.
5. In the DMZ IP Address field, enter the IP address of the computer you want to have
in the DMZ.
6. Click Apply.
To Next Page
Need help?
General
