￭ Control panel and panel platform/holder LEDs
The ACS-AP-… control panel has a status LED. The control panel mounting platform or
holder has two status LEDs. For their indications, see the following table.
IndicationLEDLocation
The unit is functioning normally.Continuous greenControl panel
Data is transferred between the PC and the unit through the USB
connection of the control panel.
Flickering green
There is an active warning in the unit.Blinking green
There is an active fault in the unit.Continuous red
There is a fault that requires the stopping and restarting of the
drive/converter/inverter.
Blinking red
The Bluetooth interface is enabled, in discoverable mode, and
ready for pairing.
Blinking blue (ACS-
AP-W only)
Data is being transferred through the Bluetooth interface of the
control panel.
Flickering blue
(ACS-AP-W only)
There is an active fault in the unit.RedControl panel
mounting platform or
holder (with the
control panel
removed)
Power supply for the control unit is OK.Green
￭ USB connector
The USB connector is used for connecting the control panel to a PC. When connected, the
control panel acts as an USB adapter for data transfer between the PC tool and the drive.
It is also possible to transfer data between the PC and the control panel through the USB
connection.
See chapter Panel-to-PC USB connection (page 71).
Control panel overview 23
To Next Page
Loading...
Need help?
General
