FunctionSub-menu
Enable or disable the panel bus. If enabled, view the status of drives in the panel bus
and select which drive to control with the control panel.
Select drive
See chapter Control of multiple drives (page 59).
Edit the contents of the Home view. See Editing the contents of the Home view (page 54)..
Edit Home view
View an active faults. See chapter Fault tracing (page 63).
Active faults
View an active warnings. See chapter Fault tracing (page 63).
Active warnings
Setting the reference
You can change the reference when the drive is in the local control mode. You can also
change the reference in remote control mode if the drive configuration permits it. Changes
take effect when saved with a key press.
1.
Press
key to switch to the local control mode, if the text in the top left corner of the
display reads Remote.
2. In the Options menu, select Reference.
3. Change the reference by using the following keys:
• Use or to select a digit to edit.
• Use and to change the value of the selected digit.
4.
Press (Save) to save the reference value, or (Cancel) to discard the changes.
The control panel returns to the Home view.
Tip: To adjust the reference from the Home view, press or and the reference changes
immediately. The reference value is highlighted when you are changing it. If you hold down
the arrow key, the rate at which the value changes accelerates.
Editing the contents of the Home view
1. In the Options menu, select Edit Home view. The Home view opens in editing mode.
2. In the editing mode, you can add, edit and delete the displayed parameters.
After editing the contents, press (Done) to confirm the changes and to exit the
editing mode and return to the Home view.
54 Functions in the Options menu
To Next Page
Loading...
Need help?
General
