cannot be edited, but it is possible to reset a counter to zero by pressing down (Reset)
for three seconds.
Note: If a trigger value is defined for the counter, the counter’s progress from zero to the
trigger value is shown as a bar graph.
Assistants
In the Assistants menu, you can launch an assistant, which is a sequence of steps that help
you to complete a task, such as setting up the control panel to use with the drive and the
motor, or fixing a fault. You can also generate a QR code, which is an optical code containing
information of the drive. The code can be read with ABB application and mobile device.
￭ Launching an assistant
1.
Use and to highlight the desired assistant.
2.
Press (Select).
3. Follow the instructions on the screen to complete the task defined by the assistant:
• Use and to select settings.
•
To edit a setting, press (Edit or Select).
• Use or to move between the pages of the assistant. The progress bar on the
upper right corner of the screen indicates the progress.
•
To exit the assistant, press (Exit).
Most settings accessed in assistant steps can also be accessed through the main Menu or
the Parameters menu, but the steps the assistants are more user-friendly.
Note: If you used the Assistants menu, complete all steps to save the changes, otherwise
the changes are canceled.
Functions in the main Menu 41
To Next Page
Loading...
Need help?
General
