The picture shows panel bus example with ACS880-01 drives. The ACX580 and ACX480
drives have dedicated panel bus adapters with two RJ-45 slots.
Selecting drive menu
In the Options menu, select Select drive which lists all the drives connected to the panel
bus and shows their current status. If panel bus is not enabled, only one drive is shown.
In the panel bus, If the connection to the currently selected drive fails, Select drive menu
is shown with the other drive list.
In the Select drive menu, any drives to which the connection is lost are shown in dimmed
text.
￭ Selecting a drive
If there are multiple drives connected to the same panel bus, you can select which drive to
control with the control panel.
1. In the Options menu, select Select drive to open a list of connected drives.
2.
Use and to move the cursor. When a drive is highlighted, the green LED on the
drive blinks for one second.
3.
Press (Select) to change control to the highlighted drive.
60 Control of multiple drives
To Next Page
Loading...
Need help?
General
