Home view
The main view of the control panel is called Home view. In the Home view, you can monitor
the status of the drive, such as its speed, torque or power. The Home view has one or more
pages, each of which can display up to three signals.
The number of pages and the signals shown on each page are customizable, and the Home
view configuration is saved to the drive whenever you change it. The maximum total number
of signals displayed varies from 9 to 21, depending on the drive. In the example below,
three Home view pages are used, showing different display formats.
Each application macro and user set has a default Home view configuration. When you
select an application macro or restore a user set, the Home view configuration changes
accordingly. There is a default Home view configuration in each drive, which can be restored
in the Primary settings (page 49) or Settings (page 48) menu.
Note: The Menu varies based on the drive/device to which the panel is connected.
The Home view opens automatically when you power up the drive. The Home view is also
displayed from the Options menu or the main Menu, if no key is pressed for 10 minutes.
Tip: You can return to the Home view from any view except special screens by holding
down the left softkey .
￭ Navigating in the Home view
•
Use and to move between the different pages of the Home view. The page numbers
are shown while you scroll between pages.
•
Use or to adjust the reference (visible in the top right corner). See also Setting the
reference (page 54).
•
Press (Menu) to open the main Menu (see Functions in the main Menu (page 33)).
•
Press (Options) to open the Options menu (see Functions in the Options
menu (page 53)).
Help
You can open a context-sensitive help page in all menus and views by pressing
button.
The help page provides information on the use of the current view or menu, or on possible
problems associated with it.
On the help page, you can press
button again or press (Exit) to exit.
Using
button, you can also view details of control panel type and version in the panel
itself. See instructions in section Applicability (page 10).
Basic operation 29
To Next Page
Loading...
Need help?
General
