Chapter 12 - Replacing Printed Circuit Boards ABB
12-6 (14) 3BHS202077 ZAB E01 Rev. C ACS 6000 Maintenance Manual
Figure 12-6 Inserting the New Flash Memory PCB
5 Put the defective board into an antistatic bag.
6 Power up the drive and confirm its proper functioning.
7 If the defective board has to be returned to ABB, particularly if the
component is still under warranty, follow the procedures as stated in
the Warranty Directives (this is recommended even if the warranty
period has expired).
To Next Page
Loading...
Need help?
General
