Main menu/Settings/General settings/Communication/SLM configuration/Rear
optical LON port/SPA
Settings for SPA over LON are made here. The operation setting is used to switch the
function on or off and the slave address setting is where the slave address is entered.
Main menu/Settings/General settings/Communication/SLM configuration
/Rear
optical LON port/Horizontal communication
This setting is used to activate or deactivate horizontal communication.
Rear optical SPA-IEC-DNP port
Main menu/Settings/General settings/Communication/SLM configuration/Rear
optical SPA-IEC-DNP port
In this submenu SPA or IEC is chosen and the necessary settings for the respective
communication protocols are made.
Main menu/Settings/General settings/Communication/SLM configuration/Rear
optical SPA-IEC port/Protocol selection
SPA and IEC cannot run at the same time and in this submenu one of the options is chosen.
Main menu/Settings/General settings/Communication/SLM configuration/Rear
optical SPA-IEC port/SPA
When SPA is chosen the baud rate and slave address are set here.
Main menu/Settings/General settings/Communication/SLM configuration/Rear
optical SPA-IEC port/IEC60870–5–103
When IEC 60870–5–103 is used the settings Slave address, Baud rate, RevPolarity
and CycMeasRepTime are done here.
9.2.2.4 Station communication
DNP3.0 for TCP/IP and EIA-485 communication protocol
Main menu/Settings/General settings/Communication/Station communication/
DNP3.0
The DNP 3.0 related parameters are found here.
GOOSE Binary receive
Main menu/Settings/General settings/Communication/Station communication/
GOOSEBinReceive/GB
1MRK506276-UUS B Section 9
Read and change settings
43
Operator's manual
To Next Page
Loading...
Need help?
General
