Main menu/Test/Function status/Monitoring/GenericMeasuredValue(GGIO)/MV
Displays the analog output from the MVGGIO block. The value shown here depends
on the settings and the logical configuration of the preprocessing blocks. The
measurement displayed may be current, voltage, frequency, phase angle etc.
11.6.11.6
Global positioning system
Main menu/Test/Function status/Monitoring/GPS
Displays the number of satellites supplying positioning and timing data to the GPS
module.
11.6.11.7 IEC61850 generic communication I/O functions 16 inputs SP16GGIO
Main menu/Test/Function status/Monitoring/IndicationBits(GGIO)/MP
Displays the output data of the SP16GGIO function.
11.6.11.8 LEDs
Main menu/Test/Function status/Monitoring/LEDs/Start and trip LEDs
Displays the status of pickup and trip LEDs.
Main menu/Test/Function status/Monitoring/LEDs/All indication LEDs
Shows new and accumulated indications and the status of the HMI indication LEDs.
11.6.11.9 Measured value expander block RANGE_XP
Main menu/Test/Function status/Monitoring/MeasValExpander/XP
Displays available instances of the function block RANGE_XP. These show the
boolean values assigned to the integer values generated by analog inputs.
11.6.11.10 IEC61850 generic communication I/O functions SPGGIO
Main menu/Test/Function status/Monitoring/SinglePointIndication(GGIO)/SP
Displays the output data of the SPGGIO function.
Section 11 1MRK506276-UUS B
Test the IED
90
Operator's manual
To Next Page
Loading...
Need help?
General
