11.6.10.3 Commands
In the commands menu it is possible to view three sets of values. These are found
under the submenus menucascade/uicontrol.
Automation bits, command function for DNP3.0 AutomationBits
Main menu/Test/Function status/Control/Commands/Automation Bits/ABI
Displays the output data of the AutomationBits function.
IEC60870-5-103
Main menu/Test/Function Status/Control/Commands/IEC60870-5-103
Under this part of the HMI tree there are the following three submenus:
•
IED Commands
• Function Commands
• User Defined Commands
Various IED, function and user defined command data can be viewed here.
Single command SINGLECMD
Main menu/Test/Function status/Control/Commands/SingleCommand/CD
There are OUT signals under the Single command menu.
Selector mini switch VSGGIO
Main menu/Test/Function status/Control/Commands/VersatileSwitch/VS
Displays the output data of the VSGGIO function.
11.6.10.4 IEC61850 generic communication I/O functions DPGGIO
Main menu/Test/Function status/Control/DoubelPointIndication(DPGGIO)/DP
Displays the output data of the DPGGIO function.
11.6.10.5 Synchronism check and energizing check SESRSYN (25)
Main menu/Test/Function status/Control/Synchronizing(RSYN,25)/SYN
Section 11 1MRK506276-UUS B
Test the IED
88
Operator's manual
To Next Page
Loading...
Need help?
General
