Commissioning
System Manual
120
6.7.4 "Smart Access Point"
Completely resetting the "Smart Access Point".
– Here all entered data, performed settings, etc., are deleted. After the reset the "Smart
Access Point" will be in the state at the point of delivery.
– After the reset, an initial commissioning of the "Smart Access Point" must be carried out.
– After the initial commissioning, old data can be read in via an available backup.
Fig. 97: Completely resetting the "Smart Access Point"
Use the following steps for the reset:
1. Connect a PC with the "Smart Access Point".
– More detailed information for connecting, see chapter 6.3.2 “Connecting a PC with the
"Smart Access Point ““ on page 83.
2. Change to the "Settings" / "Service" function.
3. Call up the "Reset default settings" function.
4. Select the areas that are to be reset.
5. Confirm the selection.
– The "Smart Access Point" is being reset.
– After the reset the connection to the "Smart Access Point" is no longer active.
– The "Smart Access Point" must be put back into operation via an initial commissioning,
see chapter 6.3.4 “Commissioning the "Smart Access Point"“ on page 89.
To Next Page
Loading...
Need help?
General
