Connection, installation / mounting
System Manual
41
1
2
3
Fig. 19: Mounting the outdoor station: Pulling the device off
2. Remove the device from the bottom.
– Press the device a few mm to the top [1] until it can be pulled off at the bottom [2].
– Pull of the device slightly at the bottom [2].
– Pull the device to the bottom [3], until the spring pins are free at the top of the device.
3. Disconnect the device.
5.3.3 Name plates
To edit the nameplate the device must be hung out.
1. Hanging the device out: see chapter 5.3.2 “Dismantling“ on page 40.
01
02
Fig. 20: Mounting the outdoor station: Editing the nameplate
2. Pull the nameplate out of the device toward the bottom.
– The nameplate is a transparent plastic insert.
– The nameplate can be pulled out with the fingers.
To Next Page
Loading...
Need help?
General
