AcerRouter 700 Series User Guide 7-1
7
Chapter 7 Messages
This chapter lists messages you may see in the AcerRouter 700 SMART message
window.
System Messages
"Account name and/or password not accepted"
User name or password failed authentication by the ISP or the remote site.
"Address already in use"
A Static Route addition specifies a destination already defined.
"Before creating a new profile, you must first configure the VPN
tunnel"
At least one VPN tunnel is required before you can configure any VPN profiles.
"Browser passing command failed. Please try again."
A transient error occurred during the communication between the browser PC and the
router. Re-try the operation.
"Call operation in progress. Request ignored"
An "Apply and Test" or "Connect" is pressed when a call is already connected or the
modem is in use.
"Cannot perform operation. Port or profile is currently disabled"
An outgoing call was attempted on a port or profile that is disabled.
"Can’t disconnect LAN"
This message is displayed when "disconnected" button is pressed for the LAN
interface.
"Clear system configuration and restart, please wait..."
This message is displayed when router is in the process of clearing all system
configuration and then resetting.
"Connection successful"
A successful connection has been established.
To Next Page
Loading...
Need help?
General
