Even if your setting is Enabled, you may also switch to the text mode
while booting by pressing after you hear a beep that indicates the
activation of the keyboard.
When set to Disabled, BIOS is in the conventional text mode where
you see the system initialization details on the screen.
2.2.10 Configuration Table
This parameter allows you to display the configuration table after
POST but before booting. The configuration table gives a summary of
the hardware devices and settings that BIOS detected during POST.
Following is a sample configuration table.
CPU/CLK : Pentium/133 MHz
Math Coprocessor:Installed
IDE Drive 0 : xxx MB
IDE Drive 1 : xxx MB
IDE Drive 2 : xxx MB
IDE Drive 3 : xxx MB
Diskette Drive A: xx-MB, xx-inch
Diskette Drive B: None
Base Memory: : xxx KB
Extended Memory: xxxx KB
Shadow RAM : xxx KB
Internal Cache : xxx KB, Enabled
External Cache : xxx KB, Enabled
Serial Port(s) : 3F8h, 2F8h
Parallel Port : 378h
Pointing Device: None
2-10 User’s Guide
To Next Page
Loading...
Need help?
General
