Automatic Measurement Controls
Time Measurements
2-57
Time Measurements
Pressing the Time menu button produces the following menus.
Table 2-28
Time Measurement Menu 1
Table 2-29
Time Measurement Menu 2
Table 2-30
Time Measurement Menu 3
The results of the automatic measurements are displayed on the bottom of the
screen. When invoking individual measurements, a maximum of three results
can be displayed at the same time. The next new measurement result selected
moves the previous measurements to the left pushing the first measurement
result off screen. The hardware counter result is displayed separately in the
upper right-hand corner of the screen. The Display All function displays all of
the measurements except for the Delay measurements at the same time.
Menu Comments
Time 1/3 Press to display menu 2 time measurements
Freq Measure the frequency of a waveform
Period Measure the period of a waveform
Rise Time Measure the rise time of a waveform
Fall Time Measure the fall time of a waveform
Menu Comments
Time 2/3 Press to display menu 3 time measurements
+Width Measure the positive pulse width of a waveform
-Width Measure the negative pulse width of a waveform
+Duty Measure the positive duty cycle of a waveform
-Duty Measure the negative duty cycle of a waveform
Menu Comments
Time 3/3 Press to display menu 1 time measurements
Delay1
→2 Measure the delay between two waveforms using the rising edges
Delay1
→2 Measure the delay between two waveforms using the falling edges
Counter Press to toggle the hardware counter on and off
To Next Page
Loading...
Need help?
General
