Ranging
(continued)
• Front-Panel Operation: Use the front-panel RANGE keys to select
autoranging or manual ranging. For frequency and period
measurements from the front panel, ranging applies to the signal’s
input voltage, not its frequency.
See also “To Select a Range,” on page 20.
• Remote Interface Operation: You can set the range using any of the
following commands.
CONFigure:<
function> {<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
MEASure:<
function>? {<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
<
function>:RANGe {<range>|MINimum|MAXimum}
<
function>:RANGe:AUTO {OFF|ON}
Chapter 3 Features and Functions
Measurement Configuration
62
To Next Page
Need help?
General
