Agilent Technologies 4288A User Manual

242 Appendix B
Information for Replacing 4278A with 4288A
At-a-Glance List of GPIB Command Correspondence
Scanner (multi
compensation)
ON/OFF MCOM{0|1} :CORR:MULT on page 161
Channel setup CNO= :CORR:MULT:CHAN on page 161
Trigger Triggers a measurement *TRG :TRIG on page 195
Trigger mode setup TRIG{1-3} :TRIG:SOUR on page 196
Delay time (trigger delay time) setup DTIM= :TRIG:DEL on page 195
Measured data
output
Data output (data transfer) format setup DFMT{1|2} :FORM on page 182
Measurement result readout DATA? :FETC? on page 181
Comparator sorting result output ON/OFF DBIN{0|1} N/A (dependent on the ON/OFF of the
comparator function)
Continuous data
output (spew-out
mode)
Start DST N/A (The continuous data output function is
not available. However, similar function can
be using :READ? on page 186.)
End DEND
Comparator ON/OFF COMP{0|1} :CALC:COMP on page 134
Sorting target parameter setup LPAR{1-6} N/A (Dependent on the measurement
parameter and cannot be set up separately.)
Reverse parameter function ON/OFF REVP{0|1} N/A
Primary parameter
limit range setup
Limit mode
(limit range designation method)
LMOD{1-3} :CALC:COMP:MODE on page 141
In sequential mode BLIM= :CALC:COMP:PRIM:BIN{1-9} on
page 142
In tolerance mode BIN{1-9}=
Nominal value (reference value)
for tolerance mode
NOM= :CALC:COMP:PRIM:NOM on page 144
Secondary parameter limit range setup SLIM= :CALC:COMP:SEC:LIM on page 145
Limit range clear CLIM :CALC:COMP:CLE on page 136
AUX BIN function ON/OFF AUX{0|1} :CALC:COMP:AUXB on page 135
Low C reject
function
OFF CREJ0 :CREJ on page 166
Low C detection boundary value
setup
CREJ{1-6} :CREJ:LIM on page 167
BIN count function ON/OFF CNT{0|1} :CALC:COMP:COUN on page 137
Count value reset RCNT :CALC:COMP:COUN:CLE on page 137
Count value readout COUN? :CALC:COMP:COUN:DATA? on page 138
:CALC:COMP:COUN:OVLD? on
page 140
Count value readout for each
channel
CCOU? :CALC:COMP:COUN:MULT:DATA? on
page 139
:CALC:COMP:COUN:MULT:OVLD? on
page 140
Save/recall Measurement condition storage (save) STOR *SAV on page 127
Measurement condition load (recall) LOAD *RCL on page 126
Table B-26 At-a-glance list of GPIB command correspondence between 4278A and 4288A
(by function)
Item to Be Set Up/Executed 4278A 4288A

Agilent Technologies 4288A Specifications

General

Brand	Agilent Technologies
Model	4288A
Category	Measuring Instruments
Language	English