4-49
MegaZoom Concepts and Oscilloscope Operation
To Autosave traces and setups
To Autosave traces and setups
1 Connect a signal to the oscilloscope and obtain a stable display.
2 Insert a disk in the oscilloscope floppy disk drive.
3Press the
Press to Autosave softkey.
Your current setup and waveform trace will be saved to an automatically
generated file name (QFILE_nn) on the floppy disk. The file name is shown in
the line above the softkeys. The nn number in the QFILE_nn file name will
automatically increment (starting at 00) each time you save a new file to floppy
disk. Up to 100 traces and setups can be saved on each floppy disk if space
permits.
When viewed from the floppy disk menu (front-panel Utility key) the trace file
will have a TRC file extension and the setup file will have a SCP file extension.
If you want to enter your own file name, overwrite an existing file name, or save
to an internal oscilloscope memory, press the Save softkey to enter the Save
menu.
To Next Page
Loading...
Need help?
General
