Using the Oscilloscope
To adjust the vertical offset
3-41
To adjust the vertical offset
• Click and hold the left mouse button on the waveform you want to
move, then drag the mouse up or down to move the waveform to the
desired offset. Release the mouse button when finished.
or
• Click and hold the left mouse button on the ground reference indicator
for the waveform you want to move, then drag the mouse to move the
waveform to the desired offset. Release the mouse button when
finished.
or
• Click the channel button in the vertical toolbar, then set the vertical
offset using the spin box control in the Channel Setup dialog box.
If you leave the mouse pointer on the waveform (without clicking the mouse),
the pointer changes into crossed arrows as a visual indicator that you can drag
the waveform when you click and hold the mouse button. If you move the mouse
up or down, the interface constrains the movement vertically and adjusts
vertical offset only. If you initially move the mouse left or right, the interface
constrains the movement horizontally and changes the horizontal position
setting only.
You can also adjust the vertical offset through the Channel Setup dialog box.
See “To access the channel setup” on page 3-44.
To Next Page
Loading...
Need help?
General
