Using the Oscilloscope
To adjust sweep speed
3-46
To adjust sweep speed
• To stretch the waveform horizontally, click the larger waveform button
next to the horizontal sweep speed setting at the bottom of the
waveform display. To shrink the waveform horizontally, click the
smaller waveform button.
See figure 3-33. The oscilloscope decreases or increases the number of seconds
per division based on your selection.
You can also adjust the sweep speed by clicking on the current setting. This
displays a pop-up numeric keypad that allows you to set an exact value for the
sweep speed. Or, you can adjust the sweep speed through the Horizontal Setup
dialog box. See “To access the horizontal setup” on page 3-48.
Figure 3-33
Adjusting Sweep Speed
Click to stretch the
waveform (fewer
seconds per
division)
Click to shrink
the waveform
(more
seconds per
division)
Click here to set
the sweep
speed directly
through a pop-
up numeric
keypad
Click here to
display the
horizontal
setup dialog
box
To Next Page
Loading...
Need help?
General
