Page 12
Transport, Lifting and Positioning
3 TRANSPORT, LIFTING
AND POSITIONING
Refrigerators are supplied assembled (apart from
standard antivibrating rubber supports, that will be
installed on site). The equipment are full of refriger-
ant and oil (except to the condensing unit), in the
quantity required for a proper operation.
3.1 Inspection
When the unit is delivered, it is recommended to
check it carefully and to identify any damage oc-
curred during transportation. The goods are shipped
ex-factory, at the buyer’s risk. Check that the delivery
includes all the components listed in the order.
In case of damage, note it down on the carrier’s de-
livery note and issue a claim according to the instruc-
tions provided in the delivery note.
In the presence of any serious damage, that does not
affect the surface only, it is recommended to inform
Itelco-Clima immediately.
Please note that Itelco-Clima may not be held liable
for any damage to the equipment during transporta-
tion, even though the carrier has been appointed by
the factory.
3.2 Lifting
The unit must lifted with cables inserted in the eye-
bolts provided. It is recommended to use a spacer to
prevent the cables from damaging the unit (see the
figure).
Before positioning the unit, make sure that the place
of installation is appropriate and sturdy enough to
hold the weight and to withstand the stress caused
by the operation of the whole assembly.
Do not displace the unit on rollers, and do
not lift it with a lift truck.
To lift and displace the unit:
h
Insert and secure eyebolts into the holes marked
on the frame.
h
Connect cables to eyebolts.
h
Insert spacer between cables.
To Next Page
Loading...
Need help?
General