Page 22
Control
6.3 Display
The display allows to indicate, in particular:
h
The temperature of the water entering the machine
in Celsius degrees
h
The alarm code, if an alarm has been activated
LED’s:
1 Displays the “Heating” mode of operation
2 Displays the “Cooling” mode of operation
3 Selects the operation mode
4 Unit start/stop; Reset of the alarms
5 Displays the parameter values and quantities
6 Displays Compressor 2 running (blinking = timing
in progress)
7 Displays Resistor on (CLH Extra Heater versions)
8 Displays Compressor 1 running (blinking = timing
in progress)
If LED’s 1 and 2 are both off, the control is in stand-
by.
If LED’s 6 and 8 are slowly blinking at the same time,
the control is in defrosting mode.
To Next Page
Loading...
Need help?
General