Replacing the computer base
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your computer.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the computer base with the screw holes on the palm-
rest assembly.
2 Replace the 11 screws (M2.5x8) that secure the computer base to the palm-
rest assembly.
3 Replace the two screws (M2x3) that secure the computer base to the palm-
rest assembly.
4 Connect the tron-light cables to the system board.
5 Route the marco-keys cable, keyboard cable, and keyboard-backlight cable
through the routing guides on the computer base.
6 Slide the macro-keys cable, keyboard cable, and keyboard-backlight cable
into their respective connectors on system board and close the latches to
secure the cables.
7 Route the antenna cables through the routing guides on the computer base.
Post-requisites
1 Replace the rear-I/O cover.
2 Replace the wireless card.
3 Replace the solid-state drive.
4 Follow the procedure from step 4 to step 6 in "Replacing the hard drive".
5 Replace the base cover.
43
To Next Page
Loading...
Need help?
General