Replacing the camera cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your computer.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance.
Procedure
1 Adhere the camera cable to the display back-cover.
2 Using the alignment posts, place the camera module on the display back-
cover.
3 Connect the camera cable to the camera module.
Post-requisites
1 Replace the display panel.
2 Replace the display bezel.
3 Replace the display assembly.
4 Follow the procedure from step 2 to step 16 in “Replacing the system board”.
5 Replace the memory modules.
6 Replace the battery.
7 Replace the computer base.
8 Replace the rear-I/O cover.
9 Replace the solid-state drive.
10 Follow the procedure from step 4 to step 6 in "Replacing the hard drive".
11 Replace the wireless card.
12 Replace the base cover.
98
To Next Page
Loading...
Need help?
General