Steps
1. Lift the Mylar to access the memory.
2. Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory module
pops up.
3. Slide and remove the memory module from the memory-module slot.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
NOTE: Repeat the steps to remove any other memory module installed in your computer.
NOTE: Note the slot and the orientation of the memory module in order to replace it in the correct slot.
NOTE: If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the
slot.
Installing the memory
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: Up to two memory modules may be installed into this computer.
The following image(s) indicate the location of the memory and provides a visual representation of the installation procedure.
26
To Next Page
Loading...
Need help?
General