Steps
1. Lift the Mylar to access the memory module.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Slide the memory module firmly at an angle, into the memory-module slot.
4. Press the memory module down until it clicks into place.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
NOTE: Repeat the steps to install a second memory into your computer.
NOTE: The securing clips return to a locked position. If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the
base cover.
About this task
The following image(s) indicate the location of the wireless card and provides a visual representation of the removal procedure.
27
To Next Page
Loading...
Need help?
General