ALLEN & HEATH XONE:43C User Manual

Allen & Heath 21 XONE:43C User Guide
MIDI
MIDI stands for Musical Instrument Digital Interface, and is an interface protocol from the
nineteen eighties to enable different keyboards, sequencers, drum machines, etc. to communicate
with each other.
MIDI is still a common interface used by most DAW software to allow remote control of various
functions within the program.
The Xone:43C has the ability to send and receive MIDI. Including 18 MIDI enabled controls, 14
Buttons and 4 Faders that can be assigned to enable control of various parameters in a DAW such
as Ableton Live or Traktor:
The Default MIDI Channel is 16 (Hex = 0F)
You can change MIDI channel by holding down the Mic/Aux channel CUE button when powering
on the mixer. The CUE button will then flash to show you are in MIDI setup mode.
Channel 1-4 CUE buttons will display the current MIDI channel number in Binary.
Use the HPF & LPF buttons to cycle through MIDI channels.
Once you have selected the MIDI channel to use, press the flashing Mic/Aux channel CUE button
to exit the MIDI setup mode.
The MIDI channel is saved in memory and will be remembered when you power off the mixer.
See the next page for a table on converting binary to decimal.

ALLEN & HEATH XONE:43C Specifications

General

Sample rate	96 kHz
Channels quantity	16 channels
Digital sound processing	24 bit
Line Signal-to-Noise Ratio (SNR)	20 dB
Total Harmonic Distortion (THD)	0.05 %
Microphone in	Yes
Headphone connectivity	3.5 mm
Product color	Black
Video capability	No
Power consumption (typical)	30 W
Equalizer bands quantity	3

Weight and Dimensions

Depth	370 mm
Width	320 mm
Height	110 mm
Weight	5200 g