1785-UM022B-EN-P - February 2002
Summary of Changes
Summary of Changes
The information below summarizes the changes to the ControlNet
PLC-5 Programmable Controllers User Manual.
To help you find new and updated information, look for the revision
bars as shown to the left of this paragraph.
New Information The following table highlights new information and where its located
in this manual. The following paragraphs describe software
requirements product enhancements.
Software and Hardweare
Requirements
Use the following table to understand specific features that are only
available with specific versions and releases of software and PLC-5
processors:
For This New Information See
Requested Packet Interval details Chapter 2
ControlNet Unscheduled Data-Transfer Operations
Scheduled Connection Types
Multicast Inputs
Distributed Keeper Functionality
Understanding ControlNet System Software Chapter 3
Using the ControlNet I/O Transfer Instruction Chapter 4
CIP Generic and Generic Bi-directional CIO Command Types
Using Selectable Timed Interrupts
Recovering from Major Fault 200
Using the General Status Indicators Chapter 5
Relay Cartridge Capability Appendix A
Processor Status File - Memory Card ID Word 68 Appendix B
Hot Backup Major Fault Codes
ControlNet I/O Map Entry Status Words Appendix D
Error Messages
Hot Backup Major Fault Codes Appendix E
If you want this feature:
You need both of these
versions of software:
And this PLC-5 Processor
(ControlNet Series F,
Revision A or later)
RSLogix5 RSNetWorx:
Standard functionality 2.2 or later 1.8 or later all
Hot Backup (1771 and Flex I/O) 3.21 or later 1.8 or later PLC-5/40 or -5/80
Multicast Outputs 3.21 or later 3.0 or later PLC-5/20, -5/40 or -5/80
SLC I/O (also with Hot Backup) 5.0 or later 3.0 or later PLC-5/40 or -5/80
AB Drives
To Next Page
Loading...
Need help?
General
