13-EN
PI SEEK Setting
1
Press and hold AUDIO/SETUP (CDE-W235BT only) for at
least 2 seconds or press SETUP (CDE-W233R only) to
activate the SETUP mode.
2
Turn the Rotary encoder to select the TUNER mode, and
then press ENTER.
3
Turn the Rotary encoder to select PI SEEK, and then press
ENTER.
4
Turn the Rotary encoder to select ON or OFF.
5
Press and hold AUDIO/SETUP (CDE-W235BT only) for at
least 2 seconds or press SETUP (CDE-W233R only) to
return to normal mode.
Notes
•Press to return to the previous mode.
• Pressing and holding for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Setting the Time to automatically Adjust
When you set to ON, the time is automatically adjusted by RDS data.
1
Press and hold AUDIO/SETUP (CDE-W235BT only) for at
least 2 seconds or press SETUP (CDE-W233R only) to
activate the SETUP selection mode.
2
Turn the Rotary encoder to select “TUNER”, and then press
ENTER.
3
Turn the Rotary encoder to select “AUTO CLOCK”, and
then press ENTER.
4
Turn the Rotary encoder to select A-CLOCK ON or
A-CLOCK OFF.
5
Press and hold AUDIO/SETUP (CDE-W235BT only) for at
least 2 seconds or press SETUP (CDE-W233R only) to
return to normal mode.
Notes
•Press to return to the previous mode.
• Pressing and holding for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Receiving Traffic Information
1
Press and hold BANDTA for at least 2 seconds so that the
“TA” indicator lights up.
2
Press or to select your desired traffic information
station.
When a traffic information station is tuned in, the “TP” indicator
lights up.
Traffic information is heard only when it is being broadcast. If
traffic information is not being broadcast, the unit is set in the
standby mode. When a traffic information broadcast begins, the
unit automatically receives it and mute the audio source (CD, FM
radio, USB AUDIO, etc.). The display shows “TRF-INFO” for 2
seconds.
When the traffic information broadcast is over, the unit will
automatically set in the standby mode.
Notes
• If you do not want to listen to the traffic information being received,
lightly press BANDTA to skip that traffic information message. The TA
mode will remain in the ON position to receive the next traffic
information message.
• If the volume level is changed while receiving traffic information, the
changed volume level will be memorized. When traffic information is
received next time, the volume level will be automatically adjusted to
the level memorized.
• In the TA mode, the SEEK tuning selects only the TP stations.
Displaying Radio Text
Text messages from a radio station can be displayed.
Press VIEW while receiving FM in the radio mode to select
the Radio Text display.
The display will change every time the button is pressed.
If there is PS (Programme Service Name):
PS (Programme Service Name)
*
RADIO TEXT
PS (Programme Service Name)
* If VIEW is pressed and held for at least 2 seconds while
displaying PS in the radio mode, frequency will be displayed for
5 seconds.
If there is no PS (Programme Service Name):
FREQUENCY RADIO TEXT FREQUENCY
The display shows “WAITING” for a few seconds, then starts
scrolling the text message.
Note
• If there is no receivable text message or the unit cannot receive a text
message properly, the display shows “NO TEXT”.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
