Amana MC22MP User Manual

11 RS2220001 Rev. 2
“RC” and KFC1 Operating Instructions
Preprogrammed Pads
Oven contains two menus with ten preset number pads
each. Heating times and power levels can be adjusted
to fit menu requirements. See separate programming
instructions packed with oven.
Number pads come factory-set to operate at full power
for the following times. MENUS 1 and 2 pads are
programmed identically at the factory.
Instructions are written for factory programmed ovens.
RC16MP, 17, 20, 22, 27 RC22LW only
Pads Cooking Time Cooking Time
1 10 seconds 5 seconds
2 20 seconds 8 seconds
3 30 seconds 13 seconds
4 45 seconds 26 seconds
5 1 minute 14 seconds
6 1 1/2 minutes 7 seconds
7 2 minutes 10 seconds
8 3 minutes No Time
9 4 minutes No Time
0 5 minutes No Time
On KFC1 units refer to Owners Manual for specific
cooking times.
Ovens that are reprogrammed may not respond exactly
as described below.
Operating Preprogrammed Pads
1. Open oven door and place food in oven. Display
shows “door”. Fan and light operate.
2. Close oven door. Display shows “MENU” and
“ITEM” (flashing). Press desired menu pad if
different than display.
NOTE: Change quantity by following procedure in step
3. If one is desired, proceed to step 4.
3. Press QUANTITY pad to increase quantities.
Cooking times are calculated automatically.
4. Press desired number pad and oven operates.
Display shows item selected and heating time
counts down. Display shows “POWER” when
microwave energy is present. Display counts down
cooking time.
5. Oven stops, display shows “EOC”, and signal
sounds when timing sequence is finished.
6. Open oven door.
Variable Time Entry
1. Open oven door and place food in oven. Display
shows "door". Oven fan and light operate.
2. Close oven door. Display shows "MENU" and
“ITEM” (flashing). Press desired menu pad if
different than display.
3. Press TIME ENTRY pad. Display shows “0000”.
4. Press numbers to enter desired cooking time.
NOTE: Change power level by following procedure in
steps 5-6. If 100 percent power is desired,
proceed to step 7.
5. Press POWER LEVEL pad. Display shows “COOK
LEVEL” and current power level.
6. Press numbers to enter desired power level. For
example, press 2 pad is 20 percent power.
7. Press START pad and oven operates. Display
shows “POWER” when microwave energy is
present. If power level was programmed, display
shows “COOK LEVEL” . Display counts down
cooking time.
8. Oven stops and signal sounds when timing
sequence is finished. Display shows “EOC”.
9. Open oven door and remove food.
Summary of Programming Multiple Stages
1. Open oven door.
2. Press pad 1 for five seconds.
3. Press desired menu pad.
4. Press desired number pad.
5. Enter desired cooking time.
6. Press STATUS pad.
7. Enter desired cooking time and power level.
NOTE: Repeat steps 6 & 7 for each stage.
8. Press START pad to lock new program.
9. Press RESET pad or close oven door to exit
programming.
NOTE: The display will show the total 4 stage cooking
time.
Operating Notes
If door is opened microwave energy ceases. Blower
continues to operate. Close door and press START
pad to continue oven operation and countdown timing.
Microwave energy ceases if STOP/RESET pad is
pressed once while oven is operating, but display
shows countdown time. Press START pad to continue
oven operation and countdown timing. Oven stops and
current program is cancelled if STOP/RESET pad is
pressed twice.
If preset pad is pushed immediately after door is
opened, then closed, a slight delay occurs before oven
starts and timing countdown begins.

Amana MC22MP Specifications

General

Brand	Amana
Model	MC22MP
Category	Microwave Oven
Language	English