RS2220001 Rev. 2 14
[QTY] Quantity (RC16MP, RC17, RC17SD,
RC20, RC22, RC27, KFC1)
1. Open oven door and place food in oven.
2. Close oven door.
3. Press QUANTITY pad.
• Oven is always set for ................. QTY1
• Press QTY once .......................... QTY2
• Press QTY twice.......................... QTY3
• Press QTY three times ................ QTY4
4. Press START pad.
NOTE: The oven will automatically adjust the time
setting for the QTY. programmed.
[LMT] Limit (All Models)
Maximum amount of time a customer can program a
pad (number).
When time LMT is changed the time will change for all
pads (numbers) in MENU1 or MENU2.
1. Enter program mode.
2. Press hidden enable pad.
3. Press MENU1 or MENU2.
NOTE: Display will show current maximum time [LMT.
4. Enter new time LMT.
5. Press MENU1 or MENU2.
6. Close door or press reset pad.
• If a time higher than the max. time limit is entered,
display will flash LMT and maximum time. Display
will then reset to “0000”.
• LMT does not affect time entry operation.
PAUS (Pause) (All Models)
Used to stop microwave power halfway through the
cooking cycle as a reminder to manipulate food.
Programming PAUS
1. Open oven door.
2. Press pad 1 for five seconds to enter programming
mode.
3. Press the desired menu pad (exp: MENU1).
4. Press the desired number pad needing
reprogrammed (exp: pad number 1) .
5. Press POWER LEVEL pad if power level other than
100% is desired. Enter desired power level. If 100%
power is desired proceed to step 6.
6. Enter desired cook time.
7. Press Pause pad.
8. Press start.
9. Press reset pad or close oven door to exit
programming mode.
Using PAUS Function
1. Open door, place food in oven.
2. Close oven door.
3. Press desired menu pad (exp: MENU1).
4. Press desired number pad (exp: pad number 1).
5. Oven starts. Display counts down.
6. Oven stops halfway through the cook cycle (oven
displays PAUS and beeps 3 times).
7. Open door and manipulate food.
8. Close door.
Specialized Programming
To Next Page
Loading...
Need help?
General
