APRILIA LEONARDO 125 User Manual

19
use and maintenance Leonardo 125 - Leonardo 150 - Leonardo 250
#/.42/,3/.4(%2)'(43)$%
/&4(%(!.$,%"!2
NOTE The electrical parts work only when the ignition switch is
in position "
n".
1) LIGHT SWITCH (
o - p -
•
) (
_
not provided)
aCAUTION
Before operating the light switch, make sure that the dim-
mer switch ( b - a ) is in position “b”.
When the light switch is in position “
•
”, the lights are off; when
the switch is in position “
p”, the parking lights and the dash-
board light are on; when the switch is in position “
o”, the
parking lights, the dashboard light and the low beam are on.
The high beam can be operated by means of the dimmer
switch (
a - b).
1a) DIMMER SWITCH (
b - a )
_
(
_ not provided for those countries where the engine
stop switch “m - n” is required)
When it is in position “
b” the parking lights, the dashboard
light and the low beam are always on.
When it is in position “
a”, the high beam comes on.
1b) ENGINE STOP SWITCH (
n - m)
(in the countries where required)
aWARNING
Do not operate the engine stop switch “n - m” in running
conditions.
This is a safety or emergency switch. With the switch in po-
sition “
n”, it is possible to start the engine; the engine can
be stopped by moving the switch to position “
m”.
aCAUTION
With stopped engine and ignition switch in position “n”,
the battery may run down.
When the vehicle has come to a halt, stop the engine, and
move the ignition switch to position “
m”.
2) START PUSH BUTTON (
r )
When the start push button “
r” is pressed, the starter makes
the engine run. For the starting, see p. 33 (STARTING).

APRILIA LEONARDO 125 Specifications

General

Brand	APRILIA
Model	LEONARDO 125
Category	Scooter
Language	English