63
use and maintenance Leonardo 125 - Leonardo 150 - Leonardo 250
#(!.').'
4(%(%!$,)'(4"5,"3
Carefully read p. 62 (BULBS).
The headlight contains:
– Two low/high beam bulbs.
– One parking light bulb (two parking light
bulbs
J
U
).
To change the bulbs, proceed as fol-
lows:
◆
Remove the front cover, see p. 53 (RE-
MOVING THE FRONT COVER).
◆
Unscrew and remove the screws (1) and
take the washers.
◆
Remove the air conveyor (2) by with-
drawing it from the upper pins.
NOTE Do not remove the protection ele-
ment (3) completely, since it is fixed to the
headlight body with two rivets.
◆
By lifting the upper fastening tang, move
the protection element (3) with your hands.
LOW BEAM BULBS/HIGH BEAM BULBS
(HALOGEN)
aCAUTION
To extract the bulb electric connector,
do not pull its electric wires.
◆
Grasp the bulb electric connector (4),
pull it and disconnect it from the bulb (5).
◆
Rotate the bulb socket (6) anticlockwise
and extract it from the reflector.
◆
Extract the bulb (5).
For the reassembly:
NOTE Insert the bulb (5) in the reflector,
by making the two elements (7) on the bulb
coincide with the respective guides (8) on
the reflector.
◆
Position the bulb socket (6) in the reflec-
tor and rotate it clockwise.
◆
Connect the bulb electric connector (4).
LOW/HIGH BEAM BULBS
J
U
◆
Rotate the bulb socket (9) anticlockwise
and extract it from its seat.
◆
Slightly press the low/high beam bulb
(10) and rotate it anticlockwise, extract it
and replace it with a new one of the
same type.
PARKING LIGHT BULBS
aCAUTION
To extract the bulb socket, do not pull
its electric wires.
◆
Grasp the bulb socket (11), pull it and
take it out of its seat.
◆
Extract the parking light bulb (12) and re-
place it with a new one of the same type.
To Next Page
Loading...
Need help?
General